SatPhones > Help Desk > Knowledgebase

K157 SMS & Remote Data Connection for Thrane/Cobham Terminals

Solution
Setup for SMS & Remote Data Connection on Thrane Units
This guide will show you how to set up the satellite terminal to allow it to receive SMS commands as
well as how to start and stop a data connection via SMS. The guide applies to Explorer 300,325, 500,
700, 727, Sailor 150, 250, and 500.
 
1. Log into the satellite terminal web interface by browsing to 192.168.0.1 from the PC connected to
the satellite terminal.
2. Click on ADMINISTRATION on the left hand side of the page.
3. The ADMINISTRATOR LOGON section will appear and you will need to input the Username
and
Password. (Default Username: admin / Password: 1234)
4. Click on Remote activation
5. When the REMOTE ACTIVATION screen appears you must do the following:
A Enable Remote activation of data sessions
B Enable Send confirmation. (This allows satellite terminal to send a reply text on whether or not
the data connection was successful.)
C Enter a Password. You may use the following characters 0-9, a-z, and A-Z.
D Input at least one phone number that terminal will accept commands from.
E Click on Apply 
 
Was this article helpful? yes / no
Related articles K46 FBB WIFI Setup
K4 Bluetooth Setup
K144 FBB FAQ
K146 How to Reset usage on Thrane SAILOR Terminal
K11 How to check voicemail from the Thrane terminal?
Article details
Article ID: 25
Category: FBB
Date added: 2015-03-02 16:20:43
Views: 146
Rating (Votes): Article not rated yet (0)

 
« Go back

 
Powered by Help Desk Software HESK, brought to you by SysAid