SatPhones > Help Desk > Knowledgebase

K45 Hughes 9201 - Wireless Setup Guide

Solution
This will walk you through the process of setting up your Hughes HNS-9201 for wireless use.

1. Go to your internet browser and type in 192.168.128.100. this will load the web interface for the terminal.

2. There is a list of catagories on the left. Locate and click where it says "ACA". after it loads. there will be a section close to the bottom to turn ACA on. the drop down menu will give you these options. "On, Off, or Data" select "ON" and save your changes by clicking on "Save Changes"

3. on the left of the web interface you will see another section, under where ACA was found, called WLAN. click on WLAN and ensure that the WLAN setting is set to "ON". This will now activate the wireless functionality of the terminal. Confirm the changes by clicking on "save Changes" located towards the bottom of the page.

4. Reboot your terminal to complete this setup. Now you will be able to see the terminal's wireless signal from your receiving device and connect to it. (Please make sure to get a GPS fix, register the unit, and connect to a data connection before attempting to use the wireless. These are needed to have the wireless work correctly)

 

Note: If you can see the wireless signal but cannot access the internet please follow only step 2 and confirm that this has been saved to ACA: "ON"

 
Was this article helpful? yes / no
Related articles K4 Bluetooth Setup
K11 How to check voicemail from the Thrane terminal?
K46 FBB WIFI Setup
K44 Hughes 9201 Manual Connection Guide
K128 General Installation Guide for BGAN Terminals
Article details
Article ID: 86
Category: Hughes HNS-9201
Date added: 2015-09-29 00:55:48
Views: 131
Rating (Votes): Article not rated yet (0)

 
« Go back

 
Powered by Help Desk Software HESK, brought to you by SysAid