Hughes 9410 Power & Data Cable – Blunt Wire, 5 m

Combined Power and Data Connection

The cable connects to the single power-and-Ethernet port on the Hughes 9410 terminal. It carries 12V DC power, ground, remote ignition sensing, and Ethernet signals, reducing the number of separate cables required between the terminal and equipment inside the vehicle.

Blunt-Wire Installation

The unterminated end exposes color-coded conductors for connection to a compatible power source and Ethernet interface:

• Red: 12V DC power
• Black: Ground
• White: Remote switch or ignition sense
• Green and white/green: Ethernet receive
• Orange and white/orange: Ethernet transmit
• Yellow: Not used

This configuration allows the cable to be integrated into a vehicle fuse panel, power-distribution system, or custom networking setup by an authorized installer.

Ethernet Termination

The exposed Ethernet conductors can be connected to the optional Hughes RJ45 Wiring Block, part number 9510250-0002. Hughes specifies a straight-through wiring arrangement when terminating the cable to an RJ45 network connection.

Compact Vehicle Installations

The 5 m cable is suitable for utility vehicles, emergency response units, fleet vehicles, and mobile work platforms where the power and networking equipment are installed close to the roof-mounted terminal. The shorter length reduces excess cable compared with the 10 m version while retaining the same power-and-data functions.

The terminal requires a 12V DC source. Hughes specifies a 10A fuse at the power source and a circuit capable of supplying at least 6A.